HEIGHT: 10' 10" Interior Ht.: 90" HITCH WT: 880# AXLE WT: 6,450#

ADA Compliant: All units are handicap accessible.

FRAME & SIDEWALL CONSTRUCTION

FRAME 2X8 high strength  tube steel rails. Welded battery rack on tongue with a steel tube 4x4 rear bumper with aluminum cover and standard safety chains. Rear skid bars for additional protection. (Rear Skid Wheels are a popular option)

SIDEWALL CONSTRUCTION

2x3 members 16" on center. Studs are bonded to 5/32 plywood paneling for high strength and lightweight. ABS fenders with galvanized wheel pans. Hand cut fiberglass insulation in sidewalls with an R 7 rating.

EXTERIOR

AXLES AND BRAKES

Unit shall have tandem 4" drop axles 5,200# each with equalized suspension. The axles are rubber torsion construction eliminating the risk of broken springs and worn parts to replace. This suspension offers a superior ride and reduced maintenance. 4 wheel 12 " electric brakes will be utilized mfg by Hayes or equal. A brake away switch will be attached to the frame as an emergency stop, in the unlikely event of unit separation.

TIRES AND WHEELS

ST225/75/R15 trailer tires on heavy duty styled white 6 lug wheels and center caps.

ROOF

A 1-piece rubber roof is provided bonded to a 7/16 OSB underlayment. Tapered 2x6 roof trusses provide a crown to the roof eliminating puddling. 4 roof vents are in place. Commercial simulated cedar shakes are on the mansard roof

FLOOR: The floor is constructed of 5/8" exterior grade tongue & groove plywood on heavy duty 2x4 support members 12" on center. Living room, and bedroom are fully carpeted with a ½" rebond pad. Kitchen and control room as well as the storage compartments have a fully insulated floor with heavy-duty vinyl under belly for maximum weather shielding at a minimal weight.

LIGHTS-INTERIOR: 12-volt fluorescent lights shall be ceiling mounted, dome lights will be in all other areas such as control room and in compartments etc as follows, total of 25 lights. (some have 2 lights in one fixture): Bedroom-6, Storage compartment-1, Bay window-1, control room-2, Kitchen-5, Living room-6, (inc. 2 over elec. fireplace)

FLOOR:  The floor is constructed of 5/8" HIP® “Huber Industrial Panel” on  2x4 floor joist 16” on center support members 16" on center. HIPh® flooring has a limited “5” year warranty.  This material is used in many high-line cargo trailers.

LIGHTS-EXTERIOR:

2 porch lights. 1 on door side and one on rear. The  have the ability to flash a distress signal to responding assistance. A light fixture is provided in the top of the generator storage compartment. Standard ICC lights are in place as required. 2 hook up lights are on the power tongue jack. A 12 volt power source with an on/off switch is prewired to the roof for a strobe light. The wall switch will be located in the control room. (4) lights are at steps.

REAR LADDER A commercially available chain escape ladder shall be bolted securely for escape simulation. The ladder will be mounted in a manner that allows shoe clearance between siding and chain ladder. A non-skid surface will be installed on treads.

WINDOWS

All windows are heat-treated safety glass. A 54 x 40 bay window in the front with 3 panels and mini blinds on each, highlights the window treatment. Shutters are provided on all side and front windows. A single hung 36"x 36" control room picture window with screen and mini blind is provided. Living room and bedroom windows are aluminum sliders, with insulated glass. Curtains, with tiebacks, valances and mini blinds with the exception of the 40"x 45" sliding window leading onto the escape ladder. Units with Severe Weather Training option do not have mini blinds.

FIREPLACE

An electric fireplace with crackling sounds will be located in the living room. It will have a screen and simulated brick face. A top mantel and two wall lights add to the warm home feel of the living room. An on/off switch will be wall mounted next to the fireplace.

KITCHEN

The kitchen shall be equipped with a functional 3-burner stove with oven. The stove will be equipped with a shut off valve in the gas supply line. A city water hook up is provided to allow use of stainless steel sink. A functional microwave oven will be provided as well as a place for a refrigerator with 4 power outlets. An exhaust fan and hood with light will also be provided. Upper and lower cabinets are in place. There are two carpeted benches provided. The front wall of the unit has a bay window with mini blinds that allows a lot of natural light.

CONTROL ROOM

A control room will be provided allowing control of many educational functions. A 911 phone system for 911 training. On/off switch for 110 volt smoke alarms. An on/off switch for bedroom electrically heated door shall be in the control room. ABS smoke ducting system (schedule 40) with control valves allowing room selection as well as an operating location and outlet for water base smoke machine. A smoke ready light in the control room will be controlled by the training officer in the bedroom. The control room has a 48" counter with storage cabinets and a 48"x12"x5" cushion on a bench for the control room operator. A 3'x3' single hung window with screen and mini blind. Observation ports in bedroom & living room

SMOKE MACHINE AND FLUID

Smoke machine and 1 case of water base smoke fluid is standard.

GENERATOR STORAGE: A generator compartment is provided to store and transport a generator. It is located so that the wheel chair ramp can be used to load and unload generator.

OUTSIDE STORAGE: An outside storage compartment is on the road side and is under the bed. A wheel chair ramp is standard.

TV CABINET: A TV cabinet and slide-out shelf is provided on the awning side of the unit. A slide out shelf will be in place. This allows the tv position to be adjusted to accommodate changing light conditions

DOORS-OUTSIDE: (2) 36"x 75" out swinging residential door is provided on the curbside. A 7"x55" door with key lock will be on left side for handicap ramp storage compartment as well as a 40"x11" door with key lock for under bed storage access.

COOLING, HEATING AND VENTILATION

The unit will include a 13,500BTU air conditioner with ducting to bedroom, living room and kitchen. Heat will be provided by a 35,000 BTU Atwood #8500 forced air furnace ducted throughout. 4 power roof vents, 1 in kitchen and 2 in bedroom shall be installed to aid in removing non toxic smoke as well as help hold the smoke to the ceiling during training.

 

ELECTRICAL-110 VOLT:

A 30-amp power supply cord shall be provided for 110-volt AC power needs. All wall receptacles are functional. Ground fault receptacles are in the kitchen as well as both outside outlets. Power is supplied through a circuit breaker built into a 55-amp solid-state power converter by Elixir or equal

ELECTRICAL-12 VOLT:12-volt power for the unit is provided by a 55-amp solid-state power converter mfg by Elixir or equal.. The converter will supply all 12-volt needs of the unit when plugged in. The unit will have a deep cycle battery and box to supply 12 volt power on short term when not plugged in.

BATTERY CUT OFF

A switch is provided to shut the battery down for storage. This eliminates a dead battery from accidentally leaving on a light during storage. Your battery will be charged and ready to go.

BACK UP BEEPER

An audible tone will be heard at the rear of the safety house warning any one in the area that the unit is moving in reverse. The tow vehicle must be properly wired to activate this alarm.

BEDROOM

The bedroom shall be on the main floor. It will be fully carpeted with rebond pad, curtains with tiebacks valances and mini blinds on the slider windows. A bed with vinyl covered mattress, bedspread and pillow sham. A carpeted bench is included. Exhaust fans shall be roof mounted with an on/off switch control, allowing the instructor to monitor smoke removal. A smoke on signal in the control room can be activated by the instructor in the bedroom. A sliding window in the rear of the unit will allow access to rear escape ladder. An electrically heated door is used to simulate fire on the opposite side.

911 PHONE  with Call back system:

        A wall phone will be located in the living room allowing a child to experience dialing 911 and reaching (control room) a firefighter or dispatcher.    An external phone jack will be located on the door side of the unit, allowing 911 training from outside the unit or to demonstrate the need to exit the home in a fire situation and call from a neighbor.

HITCH JACK

A 12-volt power tongue jack manufactured by Barker Mfg. will be in place. The unit will have manual back up capability as well as a hookup light.

STABILIZER JACK

4 BAL or equal, crank down stabilizer jacks shall be frame mounted. These jacks will stabilize the unit and eliminate suspension travel while occupied.

OUTLETS

Control room-5 Kitchen-4 Living room-3

Bedroom-4 Outside-2 Under stairs in storage-1

LIVING ROOM

Windows have curtains with tiebacks, valances and mini blinds. Electric fireplace with on/off switch. Carpeted benches. Lights above mantel. Wall mounted telephone.

AWNING

SURREY FIRE SAFETY HOUSE model 33HS1A 33 FT. 1 LEVEL

SPECIFICATION SHEET

LENGTH: 33' 6" WIDTH: 8'0" GVW: 7,130# GVWR: 10,400#

A 1-piece TPO (Thermal Poly Olyhan) roof is provided bonded to plywood underlayment. Tapered 2x6 roof trusses provide a crown to the roof eliminating puddling. 4 roof vents are in place.

FLOOR: The floor is constructed of 5/8" exterior grade tongue & groove plywood on 2x4 support members 12" on center. Living room, bedroom and stairs are fully carpeted with a ½" rebond pad. Kitchen and control room as well as the storage compartments have a fully insulated floor with heavy-duty vinyl under belly for maximum weather shielding at a minimal weight.

LIGHTS-INTERIOR: 12-volt lights shall be fluorescent lights on the ceiling except the control room. The balance of the lights shall be dome lights as follows, total of 25 lights. (some have 2 lights in one fixture): Bedroom-6, Storage compartment-1, Bay window-1,

Control room-2, Kitchen-5, Living room-6, (inc. 2 over elec. fireplace)

LIGHTS -EXTERIOR: 12 volt porch lights. One on door side and one on rear with a common switch in the kitchen at the front door. Standard ICC lights are in place as required. All ICC lights are state of the art LED technology An upper body Brake Light and turn signals. A hook up light is on the power tongue jack. A 12 volt power source with an on \ off switch is pre-wired to the roof for a strobe or rotator. The wall switch will be located in the control room. Lighted grab handles and step lights are provided.

 

Due to the constant refinement and development of the Safety House the specifications may change with out notice